Show Qos Interface; Show Qos Cos-Map - TP-Link JetStream T3700G-28TQ Reference Manual

T3700G-28TQ JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
while the queues inside WRR group follow the WRR mode. In SP + WRR mode,
TC7 is the SP group; TC0 to TC6 belong to the WRR group and the weight
value ratio of TC0 to TC6 is 1:2:4:8:16:32:64. In this way, when scheduling
queues, the switch allows TC7 to occupy the whole bandwidth following the SP
mode and TC0 to TC6 in the WRR group will take up the bandwidth according to
their ratio 1:2:4:8:16:32:64.
equ —— Equal-Mode. In this mode, all the queues occupy the bandwidth
equally. The weight value ratio of all the queues is 1:1:1:1:1:1:1:1.
Command Mode
Global Configuration Mode
Example
Specify the Schedule Mode as Weight Round Robin Mode:
T3700G-28TQ(config)#qos queue mode wrr

show qos interface

Description
The show qos interface command is used to display the configuration of QoS
based on port priority.
Syntax
show
ten-gigabitEthernet port]
Parameter
port —— The Fast/Gigabit/ten-Gigabit Ethernet port number.
Command Mode
Privileged EXEC Mode and Any Configuration Mode
Example
Display the configuration of QoS for Gigabit Ethernet port 1/0/5:
T3700G-28TQ#show qos interface gigabitEthernet 1/0/5

show qos cos-map

Description
The show qos cos-map command is used to display the configuration of
IEEE802.1P Priority and the mapping relation between cos-id and tc-id.
qos interface [ fastEthernet port | gigabitEthernet port |
184