T3700G-28TQ
JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
ip ospf dead-interval
Description
The ip ospf dead-interval command is used to set the number of seconds after
the last device hello packet was seen before its neighbors declare the OSPF
router to be down. To restore to default value, please use the no ip ospf
dead-interval command.
Syntax
ip ospf dead-interval interval
no ip ospf dead-interval
Parameter
interval—— The neighbor's failure interval, ranging from 1 to 65535 seconds
Command Mode
Interface Configuration Mode
Example
Configure the neighbor's failure interval on interface VLAN 2 as 50 seconds:
T3700G-28TQ(config-if)# ip ospf dead-interval 50
ip ospf authentication
Description
The ip ospf authentication command is used to configure the authentication
mode of the specified interface. To restore to default value, please use the no ip
ospf authentication command.
Syntax
ip ospf authentication [ message-digest ] [ null ]
no ip ospf authentication
Parameter
message-digest—— Specify the authentication type as MD5.
null —— No authentication. By default it is no authentication.
and the default is 4 times the hello interval.
376