Summary-Address - TP-Link JetStream T3700G-28TQ Reference Manual

T3700G-28TQ JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
T3700G-28TQ(config)# router ospf 1
T3700G-28TQ(config-router)# network 192.168.0.0 255.255.255.0 area
0.0.0.0

summary-address

Description
The summary-address command is used to configure a summary route. To
restore the optional parameters to default values, please use the no
summary-address with corresponding parameters. To delete the specified
summary route, please use no summary-address without any optional
parameters. By default, no external routes will be aggregated.
Use the summary-address command to summary the imported Type-5 LSA
routes in the range of aggregation address if the router you are configured is an
ASBR (Autonomous System Boundary Router).
With the summary-address command configured, the ASBR (Autonomous
System Border Router) will advertise a summary route that covers the networks
in the range to its neighbor routers. While with no summary-address command
configured, the previously aggregated external routes will be advertised again.
Syntax
summary-address ip-address mask [[tag tag] [nssa-only] | not-advertise ]
no summary-address ip-address mask [[tag tag] [nssa-only] | not-advertise ]
Parameter
ip-address—— The IP address of the summary route.
mask —— The subnet mask of the summary route, in the format of dotted
decimal notation.
tag —— The identifier of the summary route, which can be used by the routing
strategy to control the advertisement of the routes. It ranges from 0 to
4294967295 and the default value is 0.
nssa-only —— The summary route will only be advertised to the NSSA. If not
specified, the summary route will be advertised to the normal areas and the
NSSA.
354