Rule - TP-Link JetStream T3700G-28TQ Reference Manual

T3700G-28TQ JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
source-ip-mask —— The source IP address mask. It is required if you typed
the source IP address.
destination-ip —— The destination IP address contained in the rule.
destination-ip-mask —— The destination IP address mask. It is required if you
typed the destination IP address.
time-segment —— The time-range for the rule to take effect. By default, it is
not limited.
dscp —— Specify the dscp value, ranging from 0 to 63.
s-port —— The source port number.
d-port —— The destination port number.
tcpflag —— Specify the flag value when using TCP protocol.
protocol —— Configure the value of the matching protocol.
tos—— Enter the IP ToS contained in the rule.
pre —— Enter the IP Precedence contained in the rule.
Command Mode
Global Configuration Mode
Example
Create an Extended-IP ACL whose ID is 2220, and add Rule 10 for it. In the rule,
the source IP address is 192.168.0.100, the source IP address mask is
255.255.255.0, the time-range for the rule to take effect is tSeg1, and the
packets match this rule will be forwarded by the switch:
T3700G-28TQ(config)#access-list create 2220
T3700G-28TQ(config)#access-list
192.168.0.100 smask 255.255.255.0 tseg tSeg1

rule

Description
The rule command is used to configure MAC ACL rule. To delete the
corresponding rule, please use no rule command.
Syntax
rule rule-id {deny | permit} [smac source-mac smask source-mac-mask ]
[dmac destination-mac dmask destination-mac-mask ] [type ethernet-type] [pri
user-pri] [tseg time-segment]
extended 2220
198
rule 10 permit sip