Chapter 24 Qos Commands; Qos - TP-Link JetStream T3700G-28TQ Reference Manual
Jetstream 28-port gigabit stackable l3 managed switch
Hide thumbs
Also See for JetStream T3700G-28TQ:
- User manual (430 pages) ,
- Cli reference manual (424 pages) ,
- Installation manual (40 pages)
Table of Contents
Advertisement
T3700G-28TQ
JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
Chapter 24 QoS Commands
QoS (Quality of Service) function is used to optimize the network performance. It provides you with
network service experience of a better quality.
qos
Description
The qos command is used to configure CoS (Class of Service) based on port.
To return to the default configuration, please use no qos command.
Syntax
qos cos-id
no qos
Parameter
cos-id —— The priority of port. It ranges from 0 to 7, which represent CoS0-
CoS7 respectively. By default, the priority is 0.
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet/
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)
User Guidelines
Port priority is one property of the port. When the port priority is specified, the
data will be classified into the egress queue based on the CoS value of the
ingress port and the mapping relation between the CoS and TC in IEEE 802.1P.
Example
Configure the priority of port 5 as 3:
T3700G-28TQ(config)#interface gigabitEthernet 1/0/5
T3700G-28TQ(config-if)#qos 3
180
Advertisement
Table of Contents
