Ip Pim Sg-Expiry-Timer; Ip Pim Spt-Threshold Infinity - TP-Link JetStream T3700G-28TQ Reference Manual
Jetstream 28-port gigabit stackable l3 managed switch
Hide thumbs
Also See for JetStream T3700G-28TQ:
- User manual (430 pages) ,
- Cli reference manual (424 pages) ,
- Installation manual (40 pages)
Table of Contents
Advertisement
T3700G-28TQ
JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
Command Mode
Interface Configuration Mode
Example
Enable PIM dense mode on interface VLAN 2:
T3700G-28TQ(config)# interface vlan 2
T3700G-28TQ(config-if)# ip pim dense-mode
ip pim sg-expiry-timer
Description
The ip pim sg-expiry-timer command is used to specify the expiry time for
routing entries. To restore to the default timer, please use no ip pim
sg-expiry-timer command.
Syntax
ip pim sg-expiry-timer timer
no pim sg-expiry-timer
Parameter
timer —— The expiry time for the routing entries. It ranges from 60 to 65535
seconds and the default value is 210 seconds.
Command Mode
Global Configuration Mode
Example
Configure the expiry time for the routing entries as 60s:
T3700G-28TQ(config)# ip pim sg-expiry-timer 60
ip pim spt-threshold infinity
Description
The ip pim spt-threshold infinity command is used to configure all the sources
for the specified group to use the shared tree, never switching to the source tree.
To enable the leaf router to switch to the source tree as soon as it receives the
first multicast data packet, please use the no ip pim spt-threshold infinity
command.
322
Advertisement
Table of Contents
