Area Default-Cost - TP-Link JetStream T3700G-28TQ Reference Manual

T3700G-28TQ JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
any optional parameters. To restore the certain parameters to default values,
please use the no area nssa command with corresponding parameters.
Syntax
area
[ default-information-originate [ metric cost ] [ metric-type type ]]
no
[ default-information-originate [ metric cost ] [ metric-type type ]]
Parameter
area-id —— The area ID, in the format of an IP address in dotted decimal
notation or decimal value ranging from 0 to 4294967295.
no-redistribution —— Select to not import routes into the NSSA.
no-summary —— Select to not send summary LSAs into the NSSA.
default-information-originate —— Select on an ABR to allow importing default
route as type 7 LSAs into the NSSA.
cost—— The default route cost with the default value as 1. It ranges from 1 to
16777214.
type—— The default route type with the default value as 2. It is either 1 or 2.
Command Mode
Router Configuration Mode
Example
Configure Area 1 as a total NSSA area:
T3700G-28TQ(config)# router ospf 1
T3700G-28TQ(config-router)# area 1 nssa no-summary

area default-cost

Description
The area default-cost command is to configure the cost of default summary
route sent from ABR to STUB or NSSA area.
Syntax
area area-id default-cost cost
no area area-id default-cost
area-id nssa
area area-id nssa
[ no-redistribution
[ no-redistribution
367
] [ no-summary
] [ no-summary
]
]