Ip Igmp Snooping Max-Groups - TP-Link JetStream T3700G-28TQ Reference Manual

T3700G-28TQ JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
multicast groups. Leave Time ranges from 1 to 30 in seconds. By default, it is 1
seconds.
port —— Static Router Port, which is mainly used in the network with stable
topology. There are two types of port: Fast Ethernet port, ranging from 1 to 24, in
the format of 1/0/2; Gigabit Ethernet port, ranging from 1-4, in the format of
1/0/2.
vlan-id —— The VLAN ID of the multicast IP, ranging from 1 to 4094.
ip —— The static multicast IP address.
port-list —— The forward port list of the multicast group.
Command Mode
Global Configuration Mode
Example
Enable the IGMP Snooping function and modify Member Port Time as 200
seconds for VLAN1-3:
T3700G-28TQ(config)#ip igmp snooping vlan-config 1-3 mtime 200

ip igmp snooping max-groups

Description
The ip igmp snooping max-groups command is used to configure the
maximum number of groups that a port can join in. The ip igmp snooping
max-groups action is used to configure the action that the port takes when it
receives an IGMP report message and the maximum number of entries is in the
forwarding table. To remove the maximum group limitation and return to the
default of no limitation on the specified port, please use the no ip igmp
snooping max-groups command. To return to the default action of dropping
the report, please use the no ip igmp snooping max-groups action command.
These commands only apply to the dynamic multicast groups.
Syntax
ip igmp snooping max-groups [ maxgroup ]
ip igmp snooping max-groups action { drop | replace }
no ip igmp snooping max-groups
no ip igmp snooping max-groups action
227