TP-Link JetStream T3700G-28TQ Reference Manual page 37

T3700G-28TQ JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
Mode Accessing Path
User EXEC
Primary mode once it is
Mode connected with the switch.
Use the enable command to
Privileged
enter this mode from User
EXEC Mode
EXEC mode.
Global
Use the configure command to
Configuration
enter this mode from Privileged
EXEC mode.
Mode
Line
Use the line vty command
Configuration
from
mode to specify a line.
Mode
Use
VLAN
command to enter this mode
Configuration
from
Mode
mode.
Use the router ospf process-id
to enter OSPF Router mode
Router
from
mode.
Configuration
Mode Use the router rip command to
enter RIP Router mode from
Global Configuration mode.
Prompt
T3700G-28TQ>
T3700G-28TQ#
T3700G-28TQ(config)#
Global Configuration T3700G-28TQ(config- line)
the vlan vlan-list
T3700G-28TQ(config- vlan)#
Global Configuration
Global Configuration
T3700-28TQ(config- router)
18
Logout or Access the
next mode
Use the exit command to
disconnect the switch
(except that the switch is
connected through the
Console port).
Use the enable command
to access Privileged EXEC
mode.
Enter the disable or exit
command to return to User
EXEC mode.
Enter configure command
to access Global
Configuration mode.
Use the exit or the end
command or press Ctrl+Z
to return to Privileged
EXEC mode.
Use the interface
gigabitEthernet port or
interface range
gigabitEthernet port-list
command to access
interface Configuration
mode.
Use the vlan vlan-list to
access VLAN
Configuration mode.
Use the exit command to
exit to the global
configuration mode.
Press Ctrl-Z or enter end
to return to priviledged
EXEC mode.
Use the end command or
press Ctrl+Z to return to
Privileged EXEC mode.
Enter the exit or the #
command to return to
Global configuration mode.
Use the end command or
press Ctrl+Z to return to
Privileged EXEC mode.
Enter the exit or the #
command to return to
Global Configuration
mode.