Chapter 28 Mstp Commands; Spanning-Tree(Global); Spanning-Tree(Interface) - TP-Link JetStream T3700G-28TQ Reference Manual
Jetstream 28-port gigabit stackable l3 managed switch
Hide thumbs
Also See for JetStream T3700G-28TQ:
- User manual (430 pages) ,
- Cli reference manual (424 pages) ,
- Installation manual (40 pages)
Table of Contents
Advertisement
T3700G-28TQ
JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
Chapter 28 MSTP Commands
MSTP (Multiple Spanning Tree Protocol), compatible with both STP and RSTP and subject to
IEEE 802.1s, can disbranch a ring network. STP is to block redundant links and backup links as
well as optimize paths.
spanning-tree(global)
Description
The spanning-tree command is used to enable STP function globally. To
disable the STP function, please use no spanning-tree command.
Syntax
spanning-tree
no spanning-tree
Command Mode
Global Configuration Mode
Example
Enable the STP function:
T3700G-28TQ(config)#spanning-tree
spanning-tree(interface)
Description
The spanning-tree command is used to enable STP function for a port. To
disable the STP function, please use no spanning-tree command.
Syntax
spanning-tree
no spanning-tree
Command Mode
Interface Configuration Mode (interface fastEthernet / interface range
fastEthernet / interface gigabitEthernet / interface range gigabitEthernet /
interface ten-gigabitEthernet / interface range ten-gigabitEthernet)
Example
Enable the STP function for Gigabit Ethernet port 1/0/2:
207
Advertisement
Table of Contents
