T3700G-28TQ
JetStream 28-Port Gigabit Stackable L3 Managed Switch CLI Guide
ip igmp startup-query-interval
Description
The ip igmp startup-query-interval command is used to configure the interval
of Startup Query Messages that the switch sends on specified interface. To
restore to the default value on this interface, please use no ip igmp
startup-query-interval command.
Syntax
ip igmp startup-query-interval interval
no ip igmp startup-query-interval
Parameter
interval —— Specify the interval of Startup Query Messages that the switch
sends. The default value is 15 seconds.
Command Mode
Interface Configuration Mode
Example
Configure the interval of Startup Query Messages that the switch sends as 10
seconds on Interface VLAN 2:
T3700G-28TQ(config)# interface vlan 2
T3700G-28TQ(config-if)# ip igmp query-interval 10
ip igmp startup-query-count
Description
The ip igmp startup-query-count command is used to configure the number of
Startup Query Messages that the switch sends on specified interface. To restore
to
startup-query-count command.
Syntax
ip igmp startup-query-count count
no ip igmp startup-query-count
the
default
value
on
this
interface,
307
please
use
no
ip
igmp