Setting Dr Priority; Setting The Sending Interval Of The Hello Message; Limiting Pim-Sm Neighbor - Zte ZXR10 5900E Series User Manual

Command
ZXR10(config-if-vlanX)#
Command
ZXR10(config-if-vlanX)#
Command
ZXR10(config-if-vlanX)#
<acl-number>
Example

Setting DR Priority

ip pim dr-priority<priority>
It is necessary to select a DR in a shared (or Multi-Access) network
segment. Router with the highest priority will win the selection. If
the priorities are similar, the router with the greatest IP address
will be selected.
In the shared network segment connected with the multicast data
source only the DR can send the registration information to the RP.
In the shared network segment connected with the receiver only
the DR can respond to the joining and leaving messages of the
IGMP and sends the PIM joining/prune message to the upstream.
The priority of the router is contained in the exchanging Hello mes-
sage with the neighbor. The default value is 0.
Setting the Sending Interval of the
Hello Message
ip pim query-interval <seconds>

Limiting PIM-SM Neighbor

ip pim neighbor-filter
This example shows that the router 10.1.1.1 is limited to be the
PIM neighbors on the interface Vlan1.
ZXR10(config)#acl standard number 10
ZXR10(config-std-acl)#rule 1 deny 10.1.1.1 0.0.0.0
ZXR10(config-std-acl)#rule 2 permit any
ZXR10(config-router)#exit
ZXR10(config)#interface vlan 1
ZXR10(config-if-vlan1)#ip pim neighbor-filter 10
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 6 Multicast Routing Configuration
Function
This sets the DR priority.
Function
This sets the sending interval of
the Hello message.
Function
This limits some routers to be
PIM neighbor.
75