ZXR10 Command Manual (IPv6 Volume)
Purpose
Command Modes
Syntax
Syntax
Description
Defults
Example
Purpose
Command Modes
Syntax
Syntax
Description
Example
116
Confidential and Proprietary Information of ZTE CORPORATION
ZXR10(config)#router bgp 1
ZXR10(config-router)#reset ip bgp 2000::1
router bgp
Use this command to configure the Border Gateway Protocol (BGP)
on the router. Disable BGP with the no form of this command.
Global configuration
router bgp <as-number>
no router bgp [<as-number>]
<as-number>
This command is disabled by default.
This example describes how to configure the Border Gateway Pro-
tocol (BGP) with AS 1 on the router.
ZXR10(config)#router bgp 1
show bgp all neighbor
Use this command to display the related information of BGP neigh-
bor.
All modes
show bgp all neighbor [<ip-address>|<ipv6-address>]
<ip-address>
<ipv6-address>
This example describes how to display information about the
neighbor .
ZXR10#show bgp all nei 2000::1
BGP neighbor is 2000::1, remote AS 100, external link
BGP version 4, remote router ID 192.1.1.1
BGP state = Established, up for 00:00:28
hold time is 90 seconds, keepalive interval is 30 seconds
Neighbor capabilities:
Route refresh: advertised and received
Address family IPv6 Unicast: advertised and received
All received 3 messages
0 updates, 0 errs
1 opens, 0 errs
1 keepalives
0 vpnv4 refreshs, 0 ipv4 refreshs, 0 ipv4 multicast
refreshs, 0 ipv6 refreshs,
0 errs
Number of the autonomous system where the
router is located, range: 1~65535
Neighbor IP address, in the dotted decimal
format
Neighbor IPv6 address