Timers Spf - Zte ZXR10 Command Manual

ZXR10 Command Manual (IPv6 Volume)
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
66 Confidential and Proprietary Information of ZTE CORPORATION
Transmit Delay is 1 sec, State DOWN,
Timer intervals configured, Hello 10, Dead 40, Wait 40,
Retransmit 5

timers spf

Use this command to set the time interval of the recalculation of
routes after changes are received and the time interval of the cal-
culation of routes. Use the no form of this command to restore
the default value.
Router configuration
timers spf <delay><holdtime>
no timers spf
<delay>
<holdtime>
Use the command to modify the two timers and influence the time
of the calculation and generation of routes.
This example describes how to configure the two timers.
ZXR10(config)#ipv6 router ospf 1
ZXR10(config-router)#timers spf 10 20
Time interval of routes after changes
are received, unit: second, range:
0~4294967295, default: 5 seconds
Time interval of the calculation of routes, unit:
second, range: 0~4294967295, default: 10
seconds