Zte ZXR10 Command Manual page 163

Syntax
Description
group <group-addre
ss>
source <source-addr
ess>
If there is no parameter after this command, then all multicast
Instructions
routing tables will be displayed.
If there is group option after this command, then this group (*, g)
and all routing entries related with (s, g) will be displayed.
If there are group and source address options after this command,
then the specified (s, g) routing entries will be displayed.
The command information descriptions are shown below.
Field
Dense
Sparse
Connected
Pruned
RP-bit set
Source DR flag
SPT-bit set
Up Send
Join SPT
Uptime/Expires
RP
Flags
Incoming interface:
RPF nbr
Outgoing interface list
IPv6 multicast group address, X:X::X:X
IPv6 source address, X:X::X:X
Description
Dense mode
Sparse mode
Indicates that this multicast group or this
interface has the directly connected member
Outgoing interfaces of the routing entry are
empty
Indicates that the (S,G) entry exist in the
share tree
Indicates that this entry can send Register
messages of directly connected with the
source
Indicates that this routing entry receives
multicast packets from the SPT tree
Indicates this entry upsend multicast packets
Indicates the received data flow shifts to the
SPT tree
Run time and expire time of entries/outgoing
interfaces
RP related with (*,g) entries of PIM-SM
Status of multicast routing entries
Incoming interfaces of the entry
Corresponding RPF neighbor of the entries
Outgoing interface list
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 7 IPv6 Multicast Protocol
151