Show Ip Bgp Peer-Group(Bgp4+); Show Ip Bgp Protocol(Bgp4+) - Zte ZXR10 Command Manual

Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Purpose
Command Modes
Syntax
ip as-path access-list
show ip bgp peer-group(BG
P4+)
Use this command to display information about the BGP neighbor
peer group .
All modes
show ip bgp peer-group [<peer-group-name>]
<peer-group-name>
If there id no peer group specified, information about all peer
groups will be displayed.
This example describes how to display information about the
neighbor peer group.
Zxr10#show ip bgp peer-group
BGP peer-group is www remote AS 100, internal link
MEMBERS:
4.4.4.4
For address family: IPv4 Unicast
maximum limit 4294967295
Minimum time between advertisement runs is 30 seconds
Minimum time between origin runs is 15 seconds
For address family: IPv4 Multicast no activate
maximum limit 4294967295
For address family: VPNv4 Unicast no activate
maximum limit 4294967295
For address family: IPv6 Unicast no activate
maximum limit 4294967295
Descriptions of the displayed information are shown below.
Most of the content can be understood literally, also you can refer
to description of the show ip bgp neighbor command.
show ip bgp protocol(BGP
4+)
Use this command to display the configuration information of the
BGP module.
All modes
show ip bgp protocol
Confidential and Proprietary Information of ZTE CORPORATION
Peer group name
Chapter 6 BGP4+ Protocol
125