ZXR10 Command Manual (IPv6 Volume)
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
72
Confidential and Proprietary Information of ZTE CORPORATION
is-type
isis csnp-interval
Use this command to configure the interval of sending complete
sequence number packets by IS-ISv6 on the interface. Restore
default with the no form of this command.
Interface configuration
isis csnp-interval <time>[level-1 | level-2]
no isis csnp-interval [[<0-65535>[level-1 | level-2]]| level-1
| level-2]
<time>
level-1 | level-2
The csnp-interval is valid at level-1 and level-2 at the same time
by default.
This command is supported after platform version 4.6.02.
This example describes how to set the csnp interval at level-1 on
some interface as 20 seconds, and then restore the default setting.
ZXR10(config)#interface fei_1/1
ZXR10(config-if)#isis csnp-interval 20 level-1
ZXR10(config-if)#no isis csnp-interval level-1
isis hello-interval
Use this command to configure the time interval of IS-ISv6's trans-
mitting two continual hello packets on some interface. Restore de-
fault with the no form of this command.
Interface configuration
isis hello-interval {<time>| minimal}[level-1 | level-2]
no isis hello-interval [level-1 | level-2 |[minmal [level-1 |
level-2]]]
<time>
level-1 | level-2
Interval of sending complete sequence
number packets by IS-ISv6 on some interface
in seconds, range: 0~65535, default: 10
seconds
Valid range of the csnp— interval, level-1 or
level-2
Value of IS-ISv6 hello multiplier on some
interface, default: 3~1000, default: 3
Valid range of the hello multiplier, level-1 or
level-2