Ipv6 Router Isis; Is-Type - Zte ZXR10 Command Manual

ZXR10 Command Manual (IPv6 Volume)
Purpose
Command Modes
Syntax
Defaults
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
76 Confidential and Proprietary Information of ZTE CORPORATION
ZXR10(config)#interface fei_1/1
ZXR10(config-if)#isis priority 100

ipv6 router isis

Use this command to configure IS-ISv6 enabled on some interface.
Disable the function with the no form of this command.
Interface configuration

ipv6 router isis

no ipv6 router isis
IS-ISv6 is disabled by default.
This command is supported after platform version 4.6.02.
This example describes how to enable IS-ISv6 on the interface
fei_1/1, and then disable this function.
ZXR10(config)#interface fei_1/1
ZXR10(config-if)# ipv6 router isis
ZXR10(config-if)# no ipv6 router isis
router ipv6 isis

is-type

Use this command to configure the routing level of the router. Re-
store the default with the no form of this command.
Router configuration
is-type {level-1 | level-2-only | level-1-2}
no is-type
level-1 | level-2-o
nly | level-1-2
The router is at level-1-2 by default.
This command is supported after platform version 4.6.02.
This example describes how to configure the router at level-1.
ZXR10(config)#router isis
ZXR10(config-router)#is-type level-1
Router level