Ipv6 Ospf; Ipv6 Ospf Cost - Zte ZXR10 Command Manual

Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
redistribute

ipv6 ospf

Use this command to enable OSPFv3 instances on some interface.
Use the no form of this command to delete OSPFv3 instances on
the interface.
Interface configuration
ipv6 ospf <process-id> area <area-id>[instance-id <instance-
id>]
no ipv6 ospf <process-id> area <area-id>[instance-id <insta
nce-id>]
<process-id>
<area-id>
<instance-id>
This command is disabled by default.
The combination of OSPFv3 process identifier and OSPFv3 instance
identifier makes the interface support multiple OSPFv3 instances.
Only the interfaces with the same instance identifier can establish
the adjacency relationship.
This example describes how to enable OSPFv3 instances on the
interface fei_1/1.
ZXR10(config)# interface fei_1/1
ZXR10(config-if)#ipv6 ospf 15 area 3 instance-id 5

ipv6 ospf cost

Use this command to set the cost value of the interface. Restore
the default value with the no form of this command.
Interface configuration
ipv6 ospf cost <cost-value>[instance <instance-id>]
no ipv6 ospf cost [instance <instance-id>]
Confidential and Proprietary Information of ZTE CORPORATION
OPSFv3 process identifier, range: 1~65535
Sets the area identifier, and defines it as
a decimal value (0~4294967295) or an
IP address in the dotted decimal format
(A.B.C.D)
OSPFv3 instance identifier
Chapter 4 OSPFv3 Protocol
55