Router Rip; Show Ip Rip - Zte ZXR10 8900 Series Command Reference Manual

All manuals and user guides at all-guides.com
ZXR10 8900 Series Command Reference (IP Routing Volume I)
default-metric
Related
Commands
route-map

router rip

Use this command to start the RIP routing process. Close the RIP
Purpose
routing process with the no form of this command.
Global configuration
Command Modes

router rip

Syntax
no router rip
There is no RIP routing process.
Defaults
Start the RIP routing process.
Instructions
This example shows how to start the RIP routing process.
Example
ZXR10(config)#router rip
ZXR10(config-router)#
network
Related
Commands

show ip rip

Use this command to display basic information about the running
Purpose
of RIP.
All modes
Command Modes
show ip rip [vrf <vrf-name>]
Syntax
Syntax
Description
vrf <vrf-name>
This command is disabled by default.
Defaults
According to the output information of this command, the user
Instructions
can make sure whether the configuration is correct and make a
diagnosis of IP fault.
This example displays the basic information of the running of RIP.
Example
The following information indicates RIP is now in the state of run-
ning.
ZXR10#show ip rip
router rip
24 Confidential and Proprietary Information of ZTE CORPORATION
VRF name, 1~16 characters
auto-summary
default-metric 1
distance 120
validate-update-source
version 2
flash-update-threshold 5
maximum-paths 1
output-delay 5 100
timers basic 30 180 180 240
network