Show Ip Community-List(Bgp4+) - Zte ZXR10 Command Manual

ZXR10 Command Manual (IPv6 Volume)
Example
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
126 Confidential and Proprietary Information of ZTE CORPORATION
This example describes how to display the BGP instance configu-
ration information.
ZXR10#show ip bgp protocol
BGP router ID is 1.2.3.4, Local as is 100
Administratively shut down
Hold time is 30 seconds, KeepAlive time is 90 seconds
Default local preference is 100
Default export metric is 200
IGP synchronization is disabled
Default information advertise is enabled
Always compare med is enabled
Fast fallover is disabled
Client-to-client reflection is disabled
BGP cluster-id: 1.2.3.4
Ipv4 unicast client-number: 10
Vpnv4 unicast client-number: 2
Ipv4 unicast is activated
Router target if not filtered
BGP confederation id: 10
Route dampening enabled, route-map: dd
Distance : external 20 internal 200
Descriptions of the displayed information:
The router ID is selected when the BGP is created and enabled.
The Loopback address is selected preferably, and then the mini-
mum address.
The remaining displaying information is related with the configu-
ration commands. Some information is not displayed in default
configuration.
show ip community-list(BGP
4+)
Use this command to display the contents of all or a specified com-
munity list(s).
All modes
show ip community-list [<community-list-number>]
<community-list-num
ber>
If there is no parameter after this command, all the community
lists will be displayed. If there is a parameter after the command,
the specified number of the community list will be displayed.
This example describes how to display all the community lists.
ZXR10#show ip community-list
Number of the community list, range: 1~99