Passive-Interface; Redistribute(Ospfv3) - Zte ZXR10 Command Manual

Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
router-id

passive-interface

Use this command to disable an OSPFv3 interface to receive or
send packets.
Router configuration
passive-interface <interface-name >
no passive-interface <interface-name >
<interface-name >
This command is disabled by default.
Use the command to disable the interface to receive or send
OSPFv3 packets. This can help to debug and check errors.
In this example, the interface fei_3/1 is disabled to receive or send
packets.
ZXR10(config)#ipv6 router ospf 1
ZXR10(config-router)#passive-interface fei_3/1

redistribute(OSPFv3)

Use this command to redistribute the routes from other protocols
into OSPFv3. Use the no form of this command to delete the re-
distribution.
Router configuration
redistribute <protocol>[metric <metric-value>][metric-type
<type>][route-map <map-name>]
no redistribute <protocol>
<protocol>
<metric-value>
<type>
route-map
<mag-tag>
This command is disabled by default.
Confidential and Proprietary Information of ZTE CORPORATION
Interface name
Redistribution protocol name, including
connected, static, rip, bgp and isis
Sets the lsa metric after redistribution. Uses
the default– metric of the instance, range:
0~16777214
Lsa metric-type after redistribution, value:
ext-1 or ext-2, default: ext-2
Route map used by the redistribution of this
protocol
Chapter 4 OSPFv3 Protocol
61