Show Bgp All Summary - Zte ZXR10 Command Manual

ZXR10 Command Manual (IPv6 Volume)
Purpose
Command Modes
Syntax
Example
118 Confidential and Proprietary Information of ZTE CORPORATION
Fast fallover is enabled
Client-to-client reflection is enabled
Ipv4 unicast is activated
BGP FRR is disable
Router target is filtered
Route dampening is disabled
Distance : external 20 internal 200
Description of the displayed information is shown as follows:
The router identifier is selected when BGP is established and en-
abled. First select the Loopback address, and then the smallest
address.
Other displayed information is related to the corresponding con-
figuration commands. Some information is not displayed in the
default configuration.

show bgp all summary

Use this command to display the connection status of all BGP
neighbors.
All modes
show bgp all summary
This example describes how to display the connection status of
BGP neighbors under all address families.
ZXR10#show bgp all summary
Neighbor Ver As MsgRcvd
10.1.1.1 4 100 10
10.1.1.2 4 200 200
Description of the displayed information are shown below.
Field
Neighbor
Ver
AS
MsgRcvd
MsgSend
Up/Down
State
MsgSend Up/Down(s) State
2 01:01:00 Connect
199 01:00:02 Established
Description
Neighbor address
BGP neighbor version, currently supports
version 4
Neighbor AS number
Number of total messages the neighbor
receives, it will be cleared every time the
neighbor enters the Established status
Number of total messages the neighbor
sends, it will be cleared every time the
neighbor enters the Established status
Time the neighbor is in Established status or
since it leaves from the Established status. If
the neighbor never reaches the Established
status, the time will be 0
Neighbor BGP status