Network - Zte ZXR10 Command Manual

ZXR10 Command Manual (IPv6 Volume)
Syntax
Description
Defaults
Example
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Example
114 Confidential and Proprietary Information of ZTE CORPORATION
<ipv4-address>
<ipv6-address>
<peer-group-name>
<interface-name>
This command is disabled and the best local interface address is
used by default.
This example describes how to configure the loopback1 interface
for establishing a BGP connection with the neighbor 2000::1.
ZXR10(config)#router bgp 1
ZXR10(config-router)#neighbor 2000::1 update-source loopback1

network

Use this command to specify a network table for some BGP rout-
ing process. This type of network can be obtained from the con-
nected routes, dynamic routing and static route sources. Delete
the record with the no form of this command.
Router configuration and address family configuration
network <ipv4-address><net-mask>
network <ipv6-address>{<mask>}
no network <ipv4-address><net-mask>
no network <ipv6-address>{<mask>}
<ipv4-address>
<net-mask>
<ipv6-address>
<mask>
There is no network specified by default.
This example describes how to advertise local route 2000::/64 to
neighbors.
ZXR10(config)#router bgp 1
ZXR10(config-router)#address-family ipv6
ZXR10(config-router-af)#network 2000::/64
Neighbor IPv4 address
Neighbor IPv6 address
Peer group name
Specifies the name of the interface that is
the source address and used when the BGP
converses with the TCP connection.
Network address which BGP advertises to
IPv4, in the dotted decimal format
Network mask address, in the dotted decimal
foramt
IPv6 address for advertising routes
Mask of IP address for advertising routes