Spf-Interval; Summary-Prifix - Zte ZXR10 Command Manual

ZXR10 Command Manual (IPv6 Volume)
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
82 Confidential and Proprietary Information of ZTE CORPORATION

spf-interval

Use this command to control how often the Shortest Path First
(SPF) calculation iss performed .
Router configuration
spf-interval [<1 ~ 120>| level-1 [<1 ~ 120>]| level-2 <1 ~
120>]
no spf-interval
level-1 | level-2
<1 ~ 120>
The time interval between SPF calculations at level-1 and that at
level-2 are 10 seconds by default.
This command is supported after platform version 4.6.02.
This example describes how to configure the minimum amount of
time between SPF calculations as 3 seconds.
ZXR10(config)#router isis
ZXR10(comfit-router)#spf-interval 3
ZXR10(comfit-router)#no spf-interval

summary-prifix

Use this command to create aggregate addresses for routes being
redistributed from another routing protocol into IS-ISv6. Disable
the function with the no form of this command.
IPv6 address family configuration
summary-prefix <X:X::X:X>/<0~128>[level-1 | level-1-2 |
level-2 | metric]
no summary-prefix <X:X::X:X>/<0~128>
<X:X::X:X>/<0~1
28>
level-1 | level-1-2 |
level-2
metric
This command is disabled by default.
This command is supported after platform version 4.6.02.
Level of the SPF calculation
Minimum amount of time between SPF
calculations, in seconds. It can be a number
from 1 to 120.
Summary prefix designated for a range of IP
Version 6 (IPv6) prefixes
Level of the aggregate routes, default: level-2
Metric after aggregation