Ipv6 Ospf Network - Zte ZXR10 Command Manual

ZXR10 Command Manual (IPv6 Volume)
Defaults
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
58 Confidential and Proprietary Information of ZTE CORPORATION
priority <value>
instance <instance-
id>
There is no such configuration by default.
For a network of which the interface type is non-broadcast or
point-to multipoint, the only way to establish the neighbor rela-
tionship is to configure the neighbor router.
This example describes how to configure a neighbor router on the
interface fei_1/1.
ZXR10(config)# interface fei_1/1
ZXR10(config-if)#ipv6 ospf neighbor fe80::5 instance-id 5

ipv6 ospf network

ipv6 ospf network

Use this command to configure the network type on some inter-
face. Restore the default type with the no form of this command.
Interface configuration
ipv6 ospf network {broadcast | non-broadcast | point-to-m
ultipoint [non-broadcast]| point-to-point}[instance-id <inst
ance-id>]
no ipv6 ospf network [instance-id <instance-id>]
broadcast
non-broadcast
point-to-multipoint
point-to-multipoint
non-broadcast
point-to-point
instance-id
<instance-id>
The default network type depends on the attribute of network.
Point-to-multipoint type with the parameter non-broadcast and
non-broadcast type should be used with the command ipv6 ospf
neighbor.
This example describes how to configure the network as point-to-
point type.
ZXR10(config)# interface fei_1/1
Value of the priority of the neighbor router,
available only for non-broadcast interfaces,
range : 0~255, default: 1
OSPFv3 instance identifier, range: 0~255,
default: 0
Broadcast type
Non-broadcast type( it needs using with the
ipv6 ospf neighbor command)
Point-to-multipoint type
Non-broadcast type of point-to-multipoint
type (it needs using with the ipv6 ospf
neighbor command)
Point-to-point type
OSPFv3 instance identifier, range: 0~255,
default: 0