Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
isis ipv6 metric
Use this command to configure the metric of IS-ISv6 on some
interface. Restore default with the no form of this command.
Interface configuration
isis ipv6 metric < value >[level-1 | level-2]
no isis ipv6 metric [<value >[level-1 | level-2]]
<value>
level-1 | level-2
This command is valid at both level-1 and level-2 at the same time
by default.
This command is supported after platform version 4.6.02.
This command is used to configure IS-ISv6 non-wide metric value.
The wide metric value is configured with the ipv6 isis wide-met
ric command.
This example describes how to set the metric value on some in-
terface as 30.
ZXR10(config)#interface fei_1/1
ZXR10(config-if)#isis metric 30
isis priority
Use this command to configure IS-ISv6 priority of the interface on
the broadcast network. Restore default with the no form of this
command.
Interface configuration
isis priority <0~127>[level-1 | level-2]
no isis priority [[<0~127>[level-1 | level-2]]| level-1 | level
-2]
<0~127>
level-1 | level-2
This command is valid at both level-1 and level-2 at the same time
by default. The priorities at level-1 and that at level-2 are 64.
This command is supported after platform version 4.6.02.
There is no such configuration on non-broadcast network inter-
faces.
This example describes how to set the priority to 100.
Confidential and Proprietary Information of ZTE CORPORATION
Narrow metric value on some interface,
range: 1~63, default: 10
Valid range of the metric value, level-1 or
level-2
Priority, range: 0~127
Valid range of the priority, level-1 or level-2
Chapter 5 IS-ISv6 Protocol
75