Ipv6 Nat V6V4 Source List; Ipv6 Nd Managed-Config-Flag - Zte ZXR10 Command Manual

Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Purpose
icmp
bidir
This command is supported after the platform version 4.6.02.
When some packet meeting the source address which the static
rule requires is received, the translated source address will replace
the original one, and a NAT entry is generated accordingly.
This example describes how to translate the packet whose source
address is 2000:: (or 10.168.1.1) into a TCP packet whose source
address is 10.168.1.1 (or 2000::).
ZXR10(config)# ipv6 nat source

ipv6 nat v6v4 source list

Use this command to configure IPv6 to IPv4 address dynamic
translation using Network Address Translation—Protocol Transla-
tion (NAT-PT),
Global configuration
ipv6 nat v6v4 source list <access-list-name> pool <pool-na
me>
no ipv6 nat v6v4 source list <access-list-name> pool <pool-n
ame>
<access-list-name>
<pool-name>
This command is supported after the platform version 4.6.02.
When some packet of IPv6 address matching the specified ACL is
received, an IPv4 address will be taken out of the specified pool to
generate a translation entry.
In this example, a packet matching the ACL named NAT-PT-ACL
takes an IPv4 address out of the address pool named NAT-PT-POOL
to make the address translation.
ZXR10(config)#ipv6 nat v6v4

ipv6 nd managed-config-flag

Use this command to set the "managed address configuration flag"
in IPv6 router advertisements sent on the interface, that is, the
M bit of the advertisement is 1. Clear the flag from IPv6 router
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 2 IPv6 Basic Protocols
Designates the static translation only for ICMP
packets
Designates the static translation applied to
IPv4 to IPv6 address translation, and IPv6 to
IPv4 address translation
2000:: 10.168.1.1 tcp bidir
Access list name
Name of the address pool
source list nat-pt-acl pool nat-pt-pool
19