Ipv6 Ospf Transmit-Delay; Ipv6 Router Ospf - Zte ZXR10 Command Manual

ZXR10 Command Manual (IPv6 Volume)
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
60 Confidential and Proprietary Information of ZTE CORPORATION
ZXR10(config-if)#ipv6 ospf retransmit-interval 20 instance-id 5

ipv6 ospf transmit-delay

Use this command to configure the delay for the interface to trans-
mit a link state update packet. Restore the default value with the
no form of this command.
Interface configuration
ipv6 ospf transmit-delay <interval>[instance <instance-id>]
no ipv6 ospf transmit-delay [instance <instance-id>]
<interval>
<instance-id>
Use the command to modify the delay for the interface to transmit
a link state update packet.
This example describes how to configure the delay for the interface
to transmit a link state update packet as 20 seconds.
ZXR10(config)# interface fei_1/1
ZXR10(config-if)#ipv6 ospf transmit-delay 20 instance-id 5

ipv6 router ospf

Use this command to enable an OSPFv3 instance. Use the no form
of this command to delete this interface.
Interface configuration
ipv6 router ospf <process-id>
no ipv6 router ospf <process-id>
<process-id>
This command is disabled by default.
The router-id command has to be used to configure the router
identifier, and then the OSPFv3 instance run sucessfully.
This example describes how to enable an OSPFv3 instance.
ZXR10(config)#ipv6 router ospf 15
Delay for the interface to transmit a link state
update packet in seconds, range: 1~65535,
default: 1 second
OSPFv3 instance identifier, range: 0~255,
default: 0
OSPFv3 process identifier, range: 1~65535