Lsp-Refresh-Interval; Mas-Lsp-Lifetime - Zte ZXR10 Command Manual

Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
ipv6 isis circuit-type

lsp-refresh-interval

Use this command to configure the LSP refresh interval. Restore
default with the no form of this command.
Router configuration
lsp-refresh-interval <time>
no lsp-refresh-interval
< time >
This command is supported after platform version 4.6.02.
The refreshment time must be smaller than the lifetime of rout-
ing packets (Use the max-lsp-lifetime command to configure the
lifetime of routing packets). If the configured lsp-refresh-interval
is larger than the max-lsp-lifetime, the lsp-refresh-interval is en-
forced to be set as 70% of the max-lsp-lifetime.
This example describes how to set the LSP refresh interval to 800
seconds.
ZXR10(config)#router isis
ZXR10(config-router)#lsp-refresh-interval 800
max-lsp-lifetime

mas-lsp-lifetime

Use this command to configure the LSP lifetime. Restore default
with the no form of this command.
Router configuration
max-lsp-lifetime < time >
no max-lsp-lifetime
< time >
This command is supported after platform version 4.6.02.
The refresh time must be smaller than the lifetime of routing pack-
ets (Use the lsp-refresh-interval command to configure the re-
fresh interval of routing packets). If the configured max-lsp-life-
time is smaller than the lsp-refresh-interval, the lsp-refresh-inter-
val is enforced to be set as 70% of the max-lsp-lifetime.
Confidential and Proprietary Information of ZTE CORPORATION
LSP termly refresh interval, in seconds,
range: 1~65535, default: 900 seconds
LSP lifetime, in seconds, range: 1~65535,
default: 1200 seconds
Chapter 5 IS-ISv6 Protocol
77