Ipv6 Ospf Hello-Interval; Ipv6 Ospf Neighbor - Zte ZXR10 Command Manual

Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description

ipv6 ospf hello-interval

Use this command to specify the interval of hello packets on the
interface. Restore the default value with the no form of this com-
mand.
Interface configuration
ipv6 ospf hello-interval <interval>[instance <instance-id>]
no ipv6 ospf hello-interval [instance <instance-id>]
<interval>
<instance-id>
For point-to-point and broadcast interfaces, the default value is 10
seconds.
For non-broadcast and point-to-multipoint interfaces, the default
value is 30 seconds.
Use the command to modify the interval of hello packets on the
interface.
This example describes how to configure the hello interval as 20
seconds on the interface fei_1/1.
ZXR10(config)# interface fei_1/1
ZXR10(config-if)#ipv6 ospf hello-interval 20 instance 5

ipv6 ospf neighbor

Use this command to configure the neighbor router in the network
of which the interface type is nor-broadcast or point-to-multipoint.
Delete this neighbor router with the no form of this command.
Interface configuration
ipv6 ospf neighbor <X:X::X:X>[{[cost <cost-value>]|[poll-i
nterval <interval>]|[priority <value>]}][instance <instance-i
d>]
no ipv6 ospf neighbor [instance <instance-id>]
<X:X::X:X>
cost <cost-value>
poll-interval
<interval>
Confidential and Proprietary Information of ZTE CORPORATION
Interval of Hello packets on the interface in
seconds, range: 1~65535
OSPFv3 instance identifier, range: 0~255,
default: 0
Link-local address of the interface of the
neighbor router
Value of the cost to the neighbor router,
available only for point-to-multipoint
interfaces, range: 1~65535, default: 120
Poll interval of the neighbor router, available
only for non-broadcast interfaces, range:
120~65535, default: 120
Chapter 4 OSPFv3 Protocol
57