Show Ipv6 Rip; Show Ipv6 Rip Database; Show Ipv6 Rip Interface - Zte ZXR10 Command Manual

Purpose
Command Modes
Syntax
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
Purpose
Command Modes

show ipv6 rip

Use this command to display the content of RIPng.
All modes

show ipv6 rip

This command is disabled by default.
This command is used to display the content of RIPng, including
information about the timer, redistribution protocol route and en-
abled interface.
This example describes how to display information about RIPng.
ZXR10#show ipv6 rip RIPng protocol, port
multicast-group FF02::9 administrative distance is 120
default metric is 1 updates every 30 seconds, expire after
180 seconds garbage collect after 120 seconds the number of
ripng routes is 2 Redistribution:

show ipv6 rip database

Use this command to show the information about the RIPng routing
database.
All modes
show ipv6 rip database [{X:X::X:X/<0~128>|<X:X::X:X>}]
<X:X::X:X>
This command is disabled by default.
Display RIPng protocol routing database information.
This example describes how to display information about the rout-
ing database .
ZXR10#show ipv6 rip database
1::/64
nexthop: ::, via: fei_1/3
metric: 1, tag:
2007:6:5::/64
nexthop: ::, via: fei_1/8
metric: 1, tag:
5657::/16
nexthop: ::, via: fei_1/3
metric: 1, tag:

show ipv6 rip interface

Use this command to display information about the interface on
which RIPng is enabled.
All modes
Confidential and Proprietary Information of ZTE CORPORATION
Port 521,
Interfaces:
Detailed route prefix
0
0
0
Chapter 3 RIPng Protocol
fei_1/3
47