Ipv6 Nd Retransmit-Time; Ipv6 Nd Stale-Time - Zte ZXR10 Command Manual

ZXR10 Command Manual (IPv6 Volume)
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
24 Confidential and Proprietary Information of ZTE CORPORATION
show ipv6 interface
debug ipv6 nd
ipv6 nd suppress-ra
show nd6 cache

ipv6 nd retransmit-time

Use this command to set the value of "the retransmission timer"
field in the router advertisements.
Interface configuration
ipv6 nd retransmit-time <milliseconds>
no ipv6 nd retransmit-time
<milliseconds>
This command is supported after the platform version 4.6.02.
The value is the time to retransmit the neighbor request, which is
used for address resolution and neighbor detection algorithms.
This example describes how to set the retransmission time as
10000 seconds.
ZXR10(config)#int fei_3/1
ZXR10(config-if)# ipv6 nd retransmit-time 10000
show ipv6 interface
debug ipv6 nd
ipv6 nd suppress-ra
show nd6 cache

ipv6 nd stale-time

Use this command to configure the aging time of stale state of
neighbor discovery.
Global configuration
ipv6 nd stale-time<time>
<time>
This command is supported by ZXR10 6900 switch after the plat-
form version 4.6.02.
The aging time is designated as 24 hours according to RFC. How-
ever, considering the actual requirement, ZXR10 6900 make a
Retransmit time in milliseconds, default:
1000 milliseconds
Aging time in minutes, range: 1~1440