Redistribute - Zte ZXR10 Command Manual

ZXR10 Command Manual (IPv6 Volume)
Defaults
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Example
46 Confidential and Proprietary Information of ZTE CORPORATION
in | out
<metric>
<interfacename>
This command is disabled by default.
This command is used to configure the offset list and make the
received or sent routes change the metric value according to the
filtering of access lists. And this command can be enabled on a
specific interface.
When "offset-list out" policy is performed on the redistributed
routes, if there is the parameter route-map , then the priority of
metric of the route map is higher than that of the offset-list.
This example describes how to configure an offset list.
ZXR10(config)#ipv6 router rip
ZXR10(config-router)#offset-list name aclofrip in 5 fei_3/1
ipv6 acl

redistribute

Use this command to redistribute the routes obtained from other
routing protocols into the BGP routing table. Cancel the route re-
distribution with the no form of this command.
Router configuration and Address family configuration
redistribute <protocol>[metric <metric-value>][route-map
<map-tag>]
no redistribute <protocol>[metric][route-map]
<protocol>
metric <metric-val
ue>
route-map
<map-tag>
This command is disabled by default.
This example describes how to redistribute routes obtained by RIP
into the BGP routing table.
ZXR10(config)#router bgp 1
ZXR10(config-router)#address-family ipv6
ZXR10(config-router-af)#redistribute rip
Functions on the received or the sent route
Offset metric value, range: 1~6
Valid interface name
Protocol name: connected, static,
RIPOSPF-intOSPF-extISIS-1ISIS-2ISIS-1-2
Metric of the redistributed route. If there is
no metric value specified, the default value
will be used. range: 0~4294967295
Name of the route map for redistribution,
1~16 characters