Show Ip As-Path-Access-List(Bgp4+) - Zte ZXR10 Command Manual

ZXR10 Command Manual (IPv6 Volume)
Syntax
Example
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
124 Confidential and Proprietary Information of ZTE CORPORATION
show bgp ipv6 unicast summary
This example describes how to display information about the con-
nection status of all BGP IPv6 unicast address family neighbors.
ZXR10#show bgp ipv6 unicast summary
Neighbor Ver As MsgRcvd
10.1.1.1 4 100 10
10.1.1.2 4 200 200
Descriptions of the displayed information are shown below.
Filed
Neighbor
Ver
AS
MsgRcvd
MsgSend
Up/Down
State
show ip as-path-access-list
(BGP4+)
Use this command to display the contents of all or a specified reg-
ular expression access list(s).
All modes
show ip as-path-access-list [<access-list-number>]
<access-list-number>
If there is no parameter after this command , all the regular ex-
pression access lists will be displayed. If there is a parameter after
the command, the specified number regular expression will be dis-
played.
This example describes how to display the contents of all or a spec-
ified regular expression access list(s).
ZXR10#show ip as-path-access-list 1
MsgSend Up/Down(s)
2 01:01:00
199 01:00:02
Description
Neighbor IP address
BGP neighbor version number, version 4 is
supported at present
Neighbor AS number
Total messages received by the neighbor, it
is reset whenever the neighbor enters the
Established status
Total messages sent by the neighbor, it is
reset whenever the neighbor enters the
Established status
Time when the neighbor is in the Established
status or since it leaves from the Established
status. If the neighbor never enters the
Established status, this time is always 0
Neighbor status in the BGP state-machine
Number of the regular expression access list,
range: 1~199
State
Connect
Established