Tunnel Mode Ipipv6; Tunnel Mode Ipv6Ip - Zte ZXR10 Command Manual

Purpose
Command Modes
Syntax
Defaults
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions

tunnel mode ipipv6

Use this command to configure a static IPv6 tunnel and specify the
tunnel mode.
Interface configuration

tunnel mode ipipv6

There is no configuration of IPv6 tunnel by default.
This command is supported after the platform version 4.6.02.
This command defines a manual IPv6 tunnel. It needs to manually
configure an IPv4 address on the tunnel and designate the IPv4
source and destination addresses of the tunnel. The starting and
terminal points of the tunnel must support IPv4/IPv6 dual stacks.
Use the ip route command to designate tunnel interface as out-
going interface of routes. This tunnel encapsulates IPv4 packets
into IPv6 packets, and transmits them in IPv6 network.
This example describes how to establish a tunnel interface.
ZXR10(config)#interface tunnel1
This example describes how to designate the tunnel mode as ip-
ipv6.
ZXR10(config-if)#tunnel mode ipipv6
This example describes how to designate the source and destina-
tion addresses of the tunnel.
ZXR10(config-if)#tunnel source ipv6 ffe0::1
ZXR10(config-if)#tunnel destination ipv4 ffe0::2
tunnel source
tunnel destination

tunnel mode ipv6ip

Use this command to configure a static IPv6 tunnel and specify its
tunnel mode.
Interface configuration
tunnel mode ipv6ip [6to4]
6to4
IPv6 tunnels are not configured by default.
This command is supported after the platform version 4.6.02.
By default, the tunnel mode ipv6ip command defines a man-
ual IPv6 tunnel. IPv6 addresses need to be set manually on tun-
nels, as well as IPv4 source addresses and destination addresses.
The starting point and the terminal point must support IPv4/IPv6
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 2 IPv6 Basic Protocols
Make IPv6 dynamic tunnel mode use 6to4
addresses
39