Ipv6 Address - Zte ZXR10 Command Manual

ZXR10 Command Manual (IPv6 Volume)
Instructions
Example
Purpose
Command Modes
Syntax
Syntax
Description
Instructions
Example
Related
Commands
10 Confidential and Proprietary Information of ZTE CORPORATION
This command is supported after the platform version 4.6.02.
An ACL rule can be set to allow or deny the Network Address Trans-
lation-Protocol Translation (NAT-PT) for packets from some IPv6
address.
This example describes how to set an ACL named acl1 to allow
the Network Address Translation-Protocol Translation (NAT-PT) for
IPv6 packets from 2000::/96.
ZXR10(config)# ipv6 access-list acl1 permit 2000::/96

ipv6 address

Use this command to set the global address for some interface.
Delete the interface IP address with the no form of this command.
Interface configuration
ipv6 address <ipv6-prefix>/<prefix-length>
no ipv6 address [<ipv6-prefix>/<prefix-length>]
<ipv6-prefix>
<prefix-length>
This command is supported after the platform version 4.6.02.
Global addresses of the specified prefix length are allowed to be
configured on the interface. An interface can be configured with
multiple IPv6 addresses.
The use of the command no ipv6 address without any parameter
will delete all addresses on the interface.
This example describes how to set the IPv6 address whose<ipv6-
prefix> and <prefix-length> respectively as 3ffe::1 and64.
ZXR10(config)#interface fei_1/1
ZXR10(config-if)#ipv addr 3ffe::1/64
show ipv6 int
ipv6 address linklocal
Address to be configured on the interface.
It follows RFC2373. It is represented
by breaking it up into 16–bit segment.
Each segment is separated by ":". The
simplified format supported by RFC2373
can be adopted
Prefix length of the IPV6 address in
decimal format, it means the number
of continuous leading bits of the IPv6
address to make up the prefix