Ipv6 Rip Passive-Interface; Ipv6 Rip Poison-Reverse - Zte ZXR10 Command Manual

ZXR10 Command Manual (IPv6 Volume)
Instructions
Example
Purpose
Command Modes
Syntax
Defaults
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
Defaults
Instructions
Example
44 Confidential and Proprietary Information of ZTE CORPORATION
This command is used to generate the default route on the inter-
face.
This example describes how to generate the default route.
ZXR10(config)#interface fei_1/1
ZXR10(config-if)#ipv6 rip originate-default-route

ipv6 rip passive-interface

Use this command to configure the interface only sending packets.
Use the no form of this command to cancel the setting.
Interface configuration

ipv6 rip passive-interface

no ipv6 rip passive-interface
This command is disabled by default.
Use this command to make interface on which RIPng is enabled
only send but not receive RIPng packets.
This example describes how to configure an interface only sending
but not receiving packets.
ZXR10(config)#interface fei_1/1
ZXR10(config-if)#ipv6 rip passive-interface
ipv6 rip active-interface

ipv6 rip poison-reverse

Use this command to enable the poison reverse on the interface.
Use the no form of this command to disable this function.
Interface configuration

ipv6 rip poison-reverse

no ipv6 rip poison-reverse
The behavior of this command is enabled by default.
Use this command to enable the poison reverse on some interface.
This example describes how to disable the poison reverse on in-
terface fei_1/1.
ZXR10(config)#interface fei_1/1
ZXR10(config-if)#no ipv6 rip poison-reverse