Ipv6 Mtu; Ipv6 Load-Sharing - Zte ZXR10 Command Manual

Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example
Related
Commands
Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Instructions
Example

ipv6 mtu

Use this command to set the maximum transmission unit (MTU)
size of IPv6 packets sent on an interface. Restore the default MTU
size with the no form of this command.
Interface configuration
ipv6 mtu <bytes>
no ipv6 mtu
<bytes>
The default value depends on the interface medium, but the min-
imum for any interface is 1280 bytes.
This command is supported after the platform version 4.6.02.
If a nondefault value is configured for an interface, an MTU option
is included in router advertisements.
The router does not fragment forwarded packets. When the length
of the packet (IP part) exceeds the MTU of the interface, the router
will respond a"packet too big" ICMP packet to the source to make
the packet fragmented.
This example describes how to set the MTU as 1300 bytes.
ZXR10(config)#interface fei_1/1
ZXR10(config-if)#ipv6 mtu 1300
show ipv6 interface
show ipv6 mtu

ipv6 load-sharing

Use this command to set IPv6 load-sharing policy on some inter-
face. To configure IPv6 load-sharing with ipv6 load-sharing per-
destination and ipv6 load-sharing per-packet commands.
Interface configuration
ipv6 load-sharing [per-destination | per-packet]
per-destination
per-packet
The default Load-sharing policy is per-destination.
The platform version 4.8.22 and upgrade versions support this
command.
This example describes how to set load-sharing policy to
per-packet.
ZXR10(config-if)# ipv6 load-sharing per-packet
Confidential and Proprietary Information of ZTE CORPORATION
Chapter 2 IPv6 Basic Protocols
MTU in bytes, range: 1280~1500
Load-sharing policy: per-destination
Load-sharing policy: per-packet
13