Purpose
Command Modes
Syntax
Syntax
Description
Defaults
Example
Purpose
Command Modes
Syntax
ZXR10(config)#router bgp 1
ZXR10(config-router)#neighbor 2000::1 soft-reconfiguration
neighbor timers
Use this command to configure the holdtime and keepalive timers
of the neighbors. Restore to inherit the BGP timers with the no
form of this command.
Router configuration and address family configuration
neighbor
[<ipv4-address>|<ipv6-address>|<peer-group-nam
e>] timers <keepalive><holdtime>
no neighbor [<ipv4-address>|<ipv6-address>|<peer-group-na
me>] timers
<ipv4-address>
<ipv6-address>
<peer-group-name>
<keepalive>
<holdtime>
The BGP timers are inherited by default.
This example describes how to set the holdtime timer of the BGP
neighbor 2000::1 as 180 seconds and the keepalive timer as 60
seconds.
ZXR10(config)#router bgp 1
ZXR10(config-router)#neighbor 2000::1 timers 60 180
neighbor update-source
Use this command to configure the BGP session to use any oper-
atable TCP connection interface. Restore the last interface (that
is, the best local address) with the no form of this command.
Router configuration and address family configuration
neighbor
[<ipv4-address>|<ipv6-address>|<peer-group-nam
e>] update-source <interface-name>
no neighbor [<ipv4-address>|<ipv6-address>|<peer-group-na
me>] update-source
Confidential and Proprietary Information of ZTE CORPORATION
Neighbor IPv4 address
Neighbor IPv6 address
Peer group name
Time of the keepalive timer in seconds,
range: 0~65535
Time of the holdtime timer in seconds, range:
0 or 3~65535
Chapter 6 BGP4+ Protocol
113