Setting Chassis Temperature Thresholds; Refreshing The System Section - RADVision SCOPIA 400 User Manual

S C
ETTING HASSIS
T
EMPERATURE
T
HRESHOLDS
R
EFRESHING THE
S S
YSTEM ECTION
Related Topics

Setting Chassis Temperature Thresholds

Refreshing the System Section

You can set critical and safe threshold values for the SCOPIA chassis.
Procedure
1 In the Gateway Administrator interface sidebar, click System.
In the High field, enter a value in Celsius for the critical temperature
2
threshold.
The ALARM and TEMP LEDs illuminate red when the operating
temperature inside the chassis rises above this value.
In the Low field, enter a value in Celsius for the safe temperature
3
threshold.
The TEMP LED illuminates green to indicate normal operation.
The TEMP LED blinks green when the reading is inaccurate. If the LED
blinks green for a few seconds and then illuminates continuously, no
action is necessary. If the LED blinks green continuously, contact
Customer Support.
RADVISION
Click Upload to save the changes.
4
Click Refresh to refresh the System section.
5
You can refresh the information that appears in the System section to provide the
latest Gateway status.
Procedure
1 In the Gateway interface, make sure that System is selected on the
sidebar.
2 Click Refresh.
Configuring SCOPIA 400 Chassis Parameters
on page 79
on page 79
Configuring the SCOPIA Gateway 79