Table of Contents
Advertisement
C
ONFIGURING
A
DVANCED
S
ETTINGS
5
If you selected Independent at
operation to each call leg, as follows:
In the ISDN (H.320) Mode and IP (H.323) Mode or Serial (H.320) Mode
fields, choose one of the following settings:
No Encryption—Encryption support is disabled.
Best Effort—The Gateway implements a "best effort" encryption
algorithm. If an endpoint supports encryption, it connects in an
encrypted way. If not, it connects without encryption.
Encryption Required—The Gateway connects only AES 128
encrypted calls.
6
Click Upload.
In the Advanced section of the Settings tab, you can configure, enable, and
disable various advanced Gateway settings.
Procedure
In the Gateway interface, on the sidebar, click Gateway (if not already
1
selected).
Click the Settings tab.
2
3
Click Advanced.
Table 3-12
explains the IP-to-ISDN (or Serial) call settings you can
configure in this section.
Table 3-13
explains the ISDN (or Serial)-to-IP call settings you can
configure in this section.
Table 3-14
explains the IP call settings you can configure in this section.
Table 3-15
explains the ISDN call settings you can configure in this
section (available in PRI Gateways only).
Table 3-16
explains the general call settings you can configure in this
section.
Configuring Gateway Settings
step
4, you need to assign a mode of
Configuring the SCOPIA Gateway
111
Advertisement
Table of Contents
