Mounting The Scopia 400 Chassis In A 19-Inch Rack - RADVision SCOPIA 400 User Manual

Mounting the SCOPIA 400 Chassis in a 19-inch Rack

M
OUNTING THE
SCOPIA 400
C
HASSIS IN A
19- R
INCH ACK
26 SCOPIA 400/1000 Gateway User Guide
You can optionally mount the SCOPIA 400 chassis in a standard 19-inch rack.
Two mounting brackets and a set of screws are included in the SCOPIA 400
chassis shipping box.
Procedure
Disconnect all cables including the power cables.
1
2 Place the SCOPIA 400 chassis right-side up on a hard flat
surface, with the front panel facing you.
3 Position a mounting bracket over the mounting holes on each
side of the SCOPIA 400 chassis, as shown in
Pass the screws through the brackets and tighten them into the
4
screw holes on each side of the SCOPIA 400 chassis using a
suitable screwdriver.
Figure 2-4
Insert the SCOPIA 400 chassis into the 19-inch rack.
5
Fasten the brackets to the side rails of the rack.
6
Make sure that the air vents at the sides of the SCOPIA 400
7
chassis are not blocked.
Fitting a Bracket for Rack Mounting
Figure 2-4.