RADVision SCOPIA 400 User Manual page 144

Configuring Port Settings
V
IEWING
C S
ONNECTION TATUS
134 SCOPIA 400/1000 Gateway User Guide
LOS support—Enables LOS control over the synchronization
signal towards a KG-Device. Enabled for KG-Device terminal
adapters only. When checked, allows sending of a synchronization
signal to the KG-Device if the Gateway needs to update the video
image coming from the serial port.
When you select DCE in the Interface field, the Advanced button is
Note
disabled and signal state and loopback control settings are defined by the
standard logic of the Gateway.
Click Upload.
5
In the Connection Status screen you can view the configured signal state and
loopback control settings.
Procedure
In the Gateway interface, on the sidebar, click Gateway (if not already
1
selected).
Click the applicable Port tab.
2
Click the Connection Status button.
3
When DTE is selected in the Interface field, the Connection Status
screen displays the signal state and loopback control settings you
have configured in the Advanced dialog box.
When DCE is selected in the Interface field, the Connection Status
screen displays the signal state and loopback control settings defined
by the standard logic of the Gateway.
Blue lines indicate that the specified signal is on. Gray lines indicate
Note
that the specified signal is off.
Table 3-20 lists connection status and loopback control signals.