Mounting The Scopia 1000 Chassis In A 19-Inch Rack - RADVision SCOPIA 400 User Manual

M
OUNTING THE
SCOPIA 1000
C
HASSIS IN A
19- R
INCH ACK
This SCOPIA 1000 platform is intended for stationary mounting in a rack
designed to meet the physical strength requirements of NEBS GR-63-CORE
and NEBS GR 487. Be sure to mount the system in a way that ensures even
weight distribution in the rack. Uneven mechanical loading can result in a
hazardous condition. Secure all mounting bolts when installing the enclosure to
the rack. For more information, see the SCOPIA1000 Platform Guide.
The SCOPIA 1000 chassis fits standard 19" EIA racks. Mounting flanges
Note
are attached to the front of the enclosure to facilitate front mounting. The flanges
can be repositioned for center-mounting the enclosure.
It takes more than one person to safely lift the SCOPIA 1000 chassis.
Warning
Get assistance and use proper lifting techniques when moving the system. To
prevent damage to the components, never use component handles or cables to lift
or move the entire system.
Procedure
Disconnect all power sources and external connections and
1
cables.
2 Select a position in the rack that does not interfere with other
equipment and that provides safe weight distribution.
3 For efficient cooling, the area around the SCOPIA 1000
chassis intake and exhaust vents should be clear of
obstructions. The intake should be away from other system
exhausts. For more information, see the
chapter of the SCOPIA1000 Platform Guide.
Secure the mounting flanges to the front or middle of the
4
enclosure.
5 Place the enclosure in its intended location and line up the
mounting holes on the SCOPIA 1000 chassis flanges with the
rack mounting holes.
Bolt the enclosure to the rack (rack hardware is not included).
6

Mounting the SCOPIA 1000 Chassis in a 19-inch Rack

Cooling Subsystem
Installing the SCOPIA Gateway 27