Table of Contents
Advertisement
Preparing for Installation
O
SCOPIA 1000
N THE
P
LATFORM
22
SCOPIA 400/1000 Gateway User Guide
This section describes the requirements for installing the Gateway in a
SCOPIA 1000 chassis. For more information, see the SCOPIA 1000 Platform
Guide. The requirements are as follows:
This system contains board-level components that must be protected
Warning
from static discharge and physical shock. Wear a wrist strap grounded through one
of the system ESD ground jacks when handling system components. Do not
directly touch the backplane with your hand or any metal tool, or you could shock
yourself.
SCOPIA 1000 chassis
Ensure that all cover panels are in place
Ensure that all component slots are populated with a component,
filled with an air management blade (front), or covered with a blank
filler panel (rear)
Warning
Failure to cover open slots could cause overheating of
power supplies, boards, or other components, and could damage the
system.
Proper clearance at the sides of the unit to allow adequate ventilation,
and at least 20 cm clearance at the back of the chassis to allow access
to the boards and cable connections
PC with a serial port and terminal emulation software to assign the
Gateway an IP address
Dedicated IP address for the Gateway
IP address of the router the Gateway uses to communicate across the
network
IP address of the H.323 gatekeeper with which you want the Gateway
to register
Available IP network ports on the switch for the SCOPIA 1000
chassis
A grounded AC power outlet
Advertisement
Table of Contents
