Chapter 4: Setting Up The Scopia Tip Gateway; Mounting The Scopia Tip Gateway Onto The Rack Using A Shelf; Locating A Shelf In The Rack - RADVision Scopia TIP Gateway Deployment Manual

Chapter 4 | Setting up the Scopia TIP
Mount the device onto a 19" square-hole rack.
These sections describe how to set up the device:
Navigation
•

Mounting the Scopia TIP Gateway onto the Rack Using a Shelf

•
Connecting Cables to the Device
•
Configuring the Device IP Addresses
•
Verifying the Scopia TIP Gateway Installation
Mounting the Scopia TIP Gateway onto the Rack Using a
Shelf
This section describes how to mount the unit on to your rack:
Navigation
•

Locating a Shelf in the Rack

•
Checking the Accessories Required for Mounting
•
Attaching Brackets to the Scopia TIP Gateway
•
Marking the Location of the Device-fixing Cage Nuts
•
Removing the Cage Nut Screws
•
Mounting the Device-fixing Cage Nuts
•
Mounting the Scopia TIP Gateway onto the Shelf
Locating a Shelf in the Rack
About this task
Before choosing a shelf that will support the device, follow this procedure.
Deployment Guide for Scopia TIP Gateway Version 8.2
Gateway
on page 24
on page 25
on page 28
on page 18
on page 22
on page 22
on page 18
on page 19
on page 20
on page 21
on page 23
Setting up the Scopia TIP Gateway | 18