Table of Contents
Advertisement
A
G
BOUT
ATEWAY
S
ERVICES
In the Command field, enter a command.
In the Parameters field, enter the parameters for the command.
—or—
In the Available commands field, select one of the advanced
commands.
In the Available parameters field, choose from one of the parameters
that appears.
6
Click Send.
In the Response field, the Gateway indicates whether it received and
executed the command. If you send an invalid command, an "Unknown
Command" message appears.
Gateway services are the mechanism that allows IP network endpoints to choose
the type of connection they want to establish with a terminal or telephone on a
circuit-switched network. A Gateway service defines the maximum bit rate for
each channel, the media content of the stream (voice or data), and the mode of
the call (restricted or non-restricted).
A service prefix identifies a service. The service prefix is an identifier string that
can have up to 31 characters. Valid characters are 0 to 9, pound (#), asterisk (*),
or comma (,). You access a service by dialing the service prefix before the phone
number of the destination. For example, 9* would be identified by the Gateway
as a service prefix if you dialed 9*5673994.
If the Ignore caller bearer rate and force service rate setting in the
Note
Advanced section of the Settings tab is selected, a service uses the defined bit rate.
If the Ignore caller bearer rate and force service rate setting is deselected, the bit
rate defined in the service serves as the maximum limit for the service.
The Gateway has two types of services: default and user-defined. Default
services come pre-configured on the Gateway. User-defined services are services
that you can define at any time using the Gateway interface. Upon registration
with a gatekeeper, the Gateway provides the gatekeeper with a list of Gateway
services.
About Gateway Services
Configuring the SCOPIA Gateway
123
Advertisement
Table of Contents
