Table of Contents
Advertisement
Configuring Port Settings
132
SCOPIA 400/1000 Gateway User Guide
6
In the Signaling protocol field, select a signaling protocol for use in
call setup from the following list:
RS-366—Carries signaling information only.
Data Triggered—Enables the Gateway to connect a call when it
detects valid incoming data from an endpoint on the serial network.
Manual Control—Enables an Administrator to manually connect a
call via the Gateway web user interface.
Different signaling protocols are available depending on the interface
and terminal adapter that you select, as shown in
The Signaling protocol field is enabled only you select DTE in the
Interface field. The Signaling protocol field is set to RS-366 and
disabled when you select DCE in the Interface field.
In the Incoming default bandwidth field, set the rate to which the
7
Gateway forces the bandwidth of an incoming call. Available only when
DCE is selected in the Interface field.
(Optional) Click Connect Call/Disconnect Call to connect or
8
disconnect the specified call. Available only when Manual Control is
selected in the Signaling protocol field.
9
Click Reset.
Table 3-19
DTE/DCE Interface Configuration Options
Interface
Terminal Adapter Options
Selected
DTE
Common
KG-Device
DCE
Common
Related Topics
Configuring Signal State and Loopback Control Options
Viewing Connection Status
Table
3-19.
Signaling Protocol Options
RS-366, Manual Control, Data Triggered
RS-366, Manual Control, Data Triggered
RS-366
Advertisement
Table of Contents
