Table of Contents
Advertisement
B
ONDING
S
YNCHRONIZATION
6
In the Call type field, select the call type for this service: Video or Voice.
7
In the Bit rate field, select the maximum bit rate you want for this
service. If you select Auto, the Gateway determines the ISDN or serial
call rate according to the bearer capability received in the setup message
from the IP network endpoint.
The Auto setting is for video calls only.
Note
If the IP network endpoint has a configured bit rate that is not one of the
options listed in this field, the Gateway uses the default bit rate
configured in the Default Service Bit Rate field in the Advanced section
of the Settings tab.
If the Ignore caller bearer rate and force service rate field is selected
Note
when you define a bit rate for a service, the service uses the defined bit rate.
If the Ignore caller bearer rate and force service rate field is deselected, the bit
rate you define serves as the maximum limit for that service.
Related Topics
Bonding Synchronization
(PRI Gateways only) The Advanced dialog box enables you to configure a
bonding synchronization setting for the specified service.
Procedure
Send the ServiceOption advanced command with a parameter of enable
1
to activate the Advanced button.
For information on sending advanced commands, see
Advanced Commands
Click Advanced to configure bonding synchronization settings.
2
The Advanced dialog box appears.
on page 121.
Configuring the SCOPIA Gateway
About Gateway Services
Configuring
125
Advertisement
Table of Contents
